Insert the magazine release and slide lock spring (which differs among the entire-dimension and compact sizes) and link Using the slide lock.
Inspecting the rear rail segment and knocking off irregular edges created all the main difference at the back stop...no require in any respect for clamps.
That is what I've found on my SS80 (Glock 43). My gun absolutely locked up and it appeared to me that the locking block was not thoroughly level While using the frame. Your views could be appreciated. Many thanks
Then get your slide lock…it’s not symmetrical so make sure you can see the side Along with the “teeth” and also have it confront the rear. Don’t mess this up as it catches the barrel lug (aka keeps your barrel/slide from flying off).
My to start with a single expected all kinds of backwards and forwards, tapping to the rails and locking block to seat them properly, squeezing them that has a clamp to pressure them into the frame far plenty of to align the holes, and ending up beveling the finishes of the pins and hammering them in While using the rails and block below large tension.
It ended up staying a nightmare! It really is nothing like one other builds from p80. Almost the entire other products are straightforward to construct and You do not run into a lot of challenges.
Have you developed an eighty% gun? If that's so, sound off within the feedback. I’d wish to hear what consumers are making on the market.
On my up coming build I DID use a drill press to drill the holes. The plastic jig simply is not deep adequate to hold a little in perfect, perpendicular alignment for "hand drilling" - to make sure that received tossed soon after my initial frame wound up with holes on possibly side at any time so a bit off. But when utilizing the drill push, I didn't clamp the jig, I taped it pretty securely, getting care to contain the similar thickness of tape on all ends, then held the jig around the desk by hand as I launched the little bit. This permitted the jig to "Middle" because the little bit went get more info in perfectly perpendicular! The resulting pin holes were clear, facet-to-side! Then I inserted the rear rail piece and squeezed it down.
Following Allow’s put within the slide lock spring…this differs for the entire-dimension and compact measurements so be sure! It could be slightly not easy to force it in all the way into the outlet from the frame.
Initial press the result in through the “result in slot of the frame and Then you definately will be able to push the rear rail + set off housing in the again of one's frame.
You are able to check this out your self Using the slide from the frame, and It really is very evident For those who have a "real" Glock to check it to (because it will not put up with induce bar flex). The LWD connector is at any time so somewhat outside of spec, and replacing it by using a Glock connector solved the reset challenge. The Main dilemma Here's a layout flaw with result in vacation, but the LWD kit exacerbates it.
Eric, with all because of regard, I feel the LWD package isn't a good idea for these, and would strongly endorse Glock sections. I have also built 3 of them.
Disclaimer: This is only educational (and we’re not lawyers)…you’re creating a firearm so you should definitely’re legal and safe. In case you operate into difficulty when making, please seek the advice of a professional gunsmith.
one. The real rails are all away from spec in relation on the drilled holes. I spoke to a number of buddies who had also performed the Make and they all verified they had run in the exact troubles. Mainly, you are likely to see steel as well as the pin will not likely go in.